Removing
Remove the gearbox.
Remove the clutch cover with pressure plate assembly.
Install retainer (Mot. 582-01).
Remove the flywheel mounting bolts, remove the flywheel and retainer (Mot. 582-01).
Install retainer (Mot. 1677).
Remove the flywheel mounting bolts, remove the flywheel and retainer (Mot. 1677).
Installation
Clean the threaded holes on the crankshaft flange for the flywheel mounting bolts.
Degrease the bearing surface of the flywheel on the crankshaft flange.
Check the condition of the flywheel.
Install the spacer, observing the direction of installation: chamfer 8 to the side of the flywheel.
Attention! Removed bolts must not be reused.
Coat new flywheel bolts with LOCTITE FRENETANCH.
Tighten in the order shown in the figure to the required torque:
- flywheel bolts (engines K) (65 Nm);
- flywheel bolts (F4R engine) (70 Nm).