Removing
Remove the gearbox.
Install retainer (Mot. 582-01).
Turn away bolts of fastening of a casing of coupling.
Remove the clutch disc.
Use a vacuum cleaner or a clean cloth to remove dust from the clutch cover. Do not use compressed air as asbestos-containing dust inhalation is harmful to health.
Check the condition of the friction surface of the flywheel for cracks. burn and surface wear.
Check the condition of the friction linings of the clutch driven disk and if they have traces of oil or mechanical damage, replace the driven disk.
Installation
Attention! Clean the transmission input shaft splines and install the assembly without any grease.
Install the clutch disc.
Center the driven disc with a mandrel (Emb. 1518).
Wrap the fastening bolts crosswise in several stages.
Torque tighten (20 Nm) clutch cover bolts (K4M engines).