Attention! Handle the clutch pedal travel sensor with care.
The stem can only be moved when the X dimension is adjusted.
Disconnect the clutch pedal travel sensor connector.
Turn the clutch pedal travel sensor 1/4 turn counterclockwise.
Remove the clutch pedal travel sensor.
The clutch pedal travel sensor must be replaced if the stem has separated from the sensor or if more than three X-dimension changes were required for adjustment.
Measure the dimension X of the protrusion of the stem. If the X dimension is less than 17mm, adjust it. gently pulling on the end of the stem. Dimension X must be between 17mm (at least) up to 18 mm (no more).
Press the clutch pedal by hand.
Install the clutch pedal travel sensor to the pedal assembly.
Lock the clutch pedal travel sensor by turning it 1/4 turn clockwise.
When returning the clutch pedal to its original position, support it with your hand.
Note. The clutch pedal travel sensor adjusts automatically depending on the position of the pedal.
During automatic adjustment, clicks are heard when passing through the fixed positions.
Connect the connector.