Driven disk
Remove the manual gearbox.
Lock the flywheel with a latch (Mot. 1677) (1).
Remove:
- bolts (2) fixing the clutch cover with the pressure plate assembly;
- node «pressure plate - driven disc».
Clean with cleaner:
- flywheel surface for clutch disc;
- gearbox input shaft splines.
Attention. Do not lubricate the gearbox input shaft splines.
Install the clutch disc so that the end (6) was directed towards the clutch cover.
Center the driven plate using a mandrel to center the driven plates (Emb. 1780) (7).
Install the clutch cover.
Torque tighten the clutch cover mounting bolts to 15 Nm, gradually tightening them with a cross-tightening.
Remove fixtures.
Clutch Release Bearing
Remove:
- fastening bolts (1) clutch release bearing;
- clutch release bearing.
Note. To remove maximum air, when installing the clutch release thrust bearing, it must first be filled with grease.
Install a new clutch release bearing.
Torque tighten the clutch release bearing mounting bolts 21 Nm.