Caution: Use only new, non-emulsified brake fluid, do not allow contamination of the hydraulic circuit.
Attach the transparent tube (6) to the bleed nipple (in area "f").
Place the end of the tube in a container containing brake fluid located below the level of the clutch slave cylinder.
Using the clear tube (6), create an "e" curve as shown in the picture.
Attention: The end of the tube (6) must be immersed in a container with brake fluid.
Loosen the drain bolt (in area "f").
Note: Loosen the nipple to facilitate the flow of brake fluid into the container.
Fully depress the clutch pedal with your hand seven times and quickly pull it back.
Allow the clutch pedal to return to the top position.
Fill the brake fluid reservoir to the maximum level.
Loosen the drain bolt (in area "f"). Fully depress the clutch pedal by hand seven times and quickly pull it back.
On the final movement, leave the clutch pedal in the down position.
Tighten the bleed nipple (in zone "f").
Repeat the operation if necessary.
Fill the brake fluid reservoir to the "MAX" level. Quickly press and release the clutch pedal 40 times.
Start the engine.
Apply the parking brake. Engage the gear.
Check that the start of clutch slippage occurs at a stroke (X) of at least 45 mm (dimension "X" is provided for reference).
Repeat the pumping operations (if necessary).