Disconnect the battery.
Remove the engine top cover and air intake grille.
Remove the air filter housing.
Remove the brake fluid from the reservoir with a syringe so that its level is below the fluid supply hole to the master cylinder. Raise the latch (1).
Pull the hydraulic clutch line out of the fitting one click.
Place a rag under the air vent.
Depress the clutch pedal by hand to remove fluid from the master cylinder and tube.
Raise the latch again.
Disconnect the pipeline from the working cylinder.
Insert the plugs into the holes.
Press the latch with your hand (1), while pulling out the pipeline.
Attention. Do not pull on the latch. In case of any erroneous action, the pipeline must be replaced.
Pull the hydraulic clutch line out of the fitting one click.
Place a rag under the air vent.
Press your hand on the pedal (to remove fluid from the master cylinder and piping).
Click on the latch.
Disconnect the pipeline from the working cylinder.
Insert the plugs into the holes. Check the condition of the gaskets. Installation is made in an order, the return to removal.
Bleed the air from the hydraulic clutch.
Check clutch operation.
Connect the battery.