Fill the hydraulic fluid reservoir with certified brake fluid.
Attach the installation (Ms. 554-07) to the hydraulic drive reservoir.
Remove the plug from the air bleed nipple.
Place a transparent tube on the bleed nipple of the clutch slave cylinder, lowering its end into an empty container installed below the bleed nipple.
Fig. 3.1. Preparation for bleeding the clutch slave cylinder: 1 – bleed nipple; 2 – retainer
Press the lock (Fig. 3.1).
Attention! Do not pull the lock. Any erroneous action requires replacement of the pipeline.
Open the air bleed nipple by pulling the clutch hydraulic line out one click.
Turn on the pump of the installation (Ms. 554-07).
Wait until there are no air bubbles in the brake fluid flowing into the container.
Caution! Make sure that the fluid level is above the hydraulic line nipple when bleeding air.
The fixation of the clutch hydraulic drive pipeline should be accompanied by a characteristic click.
Shift the clutch in and out about ten times.