Usable fuel tank capacity: 50 liters (approximately).
To open the fuel filler door A, insert your finger into recess B.
To close the fuel filler door A, push it in by hand until it stops. Depending on the vehicle equipment, plug 1 can be unlocked with the ignition key.
It can also be connected to the car with a plastic thread.
For temporary fastening of the fuel tank filler cap during refueling, a holder 2 is provided on the hatch.
Fuel quality
Gasoline-powered vehicle Use only unleaded gasoline. The octane number of the fuel must match the number indicated on the C label on the filler cap.
Diesel vehicles
Use only the diesel fuel specified on label C on the fuel filler cap.
Ethanol-based vehicles
Use only unleaded gasoline or fuel with an ethanol content of 85% or less (E85).
At very low ambient temperatures, the engine may be difficult to start or may not start. Note: The use of this type of fuel may lead to an increase in fuel consumption.
When changing fuel, the engine must adjust, which may cause some disturbances in its operation (longer start-up, interruptions in operation, etc.) within minutes.
Refueling
Insert the gun to retract valve A and push the gun all the way before turning the gun to fill the fuel tank (to prevent fuel splashing). Hold it in this position until the end of refueling. After the first automatic fuel stop when refueling, a maximum of two more fuel cuts can be made so that there is free space in the tank to allow the fuel to expand as the temperature rises. When refueling, make sure that no water enters the fuel tank. Valve A and the area around it must remain clean.
Cars with a gasoline engine
The use of leaded gasoline may cause failure of the aftertreatment system and void the manufacturer's warranty.
To prevent the possibility of refueling with leaded gasoline, the fuel filler neck has a safety device that allows only the unleaded fuel dispenser to be used for refueling.
Booster pump (diesel engine versions)
After running out of fuel before starting the engine, you must refill the fuel circuit.
Note: The manual fuel priming pump is located on the right side of the engine compartment.
Using pump 2, prime the circuit until fuel flows into tube 1.
If the engine does not start after several attempts, you should contact the service station.