Fig. 3.2. Adjusting the clutch drive: 1 – adjusting nut; 2 – lock nut; 3 – cable sheath stopper; 4 – clutch release fork
Adjust the stroke of the clutch cable using the nut on the end on the gearbox side (Fig. 3.2).
Loosen the locknut.
Adjust the clutch cable stroke by loosening or tightening the nut.
Tighten the lock nut to the specified torque (8 Nm).
Checking the adjustment
Fig. 3.2. Adjusting the clutch drive: 1 – adjusting nut; 2 – lock nut; 3 – cable sheath stopper; 4 – clutch release fork
(This note was copied from the resource: «RENAULTBOOK»)
Using a caliper, measure the distance between the cable housing stop and the end of the clutch release fork (see fig. 3.2):
- with the clutch pedal in its initial position;
- with the clutch pedal pressed all the way down.
Fig. 3.3. Clutch release fork stroke
The clutch release fork stroke should be equal to: (x)=29.5 mm ±0.5 mm (Fig. 3.3).