General description of clutch The clutch when shifting gears disconnects the power circuit between the engine and the gearbox, and during acceleration, using friction, ensures their smooth, jerk-free, kinematic connection. The clutch consists of a...
Clutch — removal 1. Remove a transmission, the corresponding chapter see. 2. Mark the position of the pressure plate on the flywheel with a felt-tip pen or scriber (see arrow in illustration). 2.2 Mark the position of the pressure plate...
Clutch — check 7. Check the condition of the diaphragm spring (see arrows in illustration). 2.7 Check the condition of the diaphragm spring (see arrows) 8. Check up fastening of a spring between a pressure disk and a cover and be...
Clutch — Installation 15. Clean the gearbox input shaft splines and lubricate them with a thin layer of molybdenum grease, such as MOLYKOTE BR 2 (see illustration). 2.15 Clean the gearbox input shaft splines and lubricate them with a thin...
Clutch release bearing — removal and installation The release bearing should be replaced if it «making noise» or its progress is difficult. It is also recommended to change the release bearing, if the car has a sufficiently high mileage, it is necessary to replace the...
Automatic Clutch Cable Adjuster — Check The automatic clutch cable adjuster on the clutch pedal provides proper pedal free play so pedal travel does not need to be adjusted during vehicle maintenance. Spring R constantly tightens the S segment of the...
Clutch cable — removal and installation Removing 1. Disconnect the clutch cable from the clutch release fork. 2. Depress the clutch pedal and hold it in this position. This will pull the cable. 3. Disconnect the end of the cable from segment S of the adjuster...