1. Brake the vehicle with the parking brake and set the wheel chocks («shoes») under the rear wheels. Loosen the hub nut and wheel bolts. Raise the front of the vehicle with a jack and place it on stands. Remove the wheel.
Attention! Loosen and tighten the wheel bolts and hub nut only with the vehicle on the ground.
2. Remove the front wheel brake caliper assembly (see «Front wheel brake caliper replacement»), without disconnecting the brake hose, and secure it with wire without twisting or pulling the hose.
3. Turn away a nut and take a finger of the spherical joint of a tip of steering draft from a boss of a rotary fist (see «Replacing the outer tie rod end»).
4. Remove the brake disc (see «Brake disc replacement»).
5. Turn out three bolts of fastening of a brake board to a rotary fist...
6....and remove it.
7. Turn away a nave nut.
8. Turn away nuts of bolts of fastening of a rotary fist to a shock-absorber rack and take bolts.
9. Remove the ball joint pin from the steering knuckle (see «Replacing the front suspension arm»).
10. Remove the steering knuckle from the CV joint shank.
11. Install the parts in the reverse order of removal. Tighten bolts and nuts to the torque specified in Appendix 1.