Torque | |
Bolts of fastening of a shock-absorber rack to a rotary fist | 105 Nm |
Nut or bolt of fastening of spherical support of suspension arms | 62 Nm |
Nut of fastening of a pin of a spherical hinge of a tip of steering draught | 37 Nm |
hub nut | 280 Nm |
Bolts of fastening of directing pads | 105 Nm |
Removing
Place the car on a two post lift.
Unlock the steering wheel.
Remove the front wheel from the corresponding side.
Remove the wheel speed sensor (depending on equipment level).
Loosen the front brake shoe guide bolts (1).
Hang the front brake shoe guide assembly with caliper and shoes to the suspension spring.
Remove:
- hub nut (4) using the device,
- front brake disc.
Wheel protection
Remove the front brake disc guard.
Remove:
- fastening nut (3) ball joint pin of the tie rod end,
- nut or bolt for fastening the ball bearings of the suspension arms,
- bolts (2) fastening shock absorber struts to the steering knuckles.
Remove the tie rod end ball joint using the tool (5).
Slide the front wheel drive shaft away from the hub axle using the assembled tools.
Remove the steering knuckle.
Installation
Parts that must be replaced:
- Front wheel hub nut
- Nut of fastening of a finger of a spherical hinge of a tip of steering draft,
- Front suspension ball joint nut,
- Front shock absorber lower nut.
Install:
- rounded fist,
- tie rod end ball joint,
- bolts for fastening the shock absorber struts to the steering knuckles,
- the lower ball joint of the lower suspension arm.
Install the brake disc guard.
Install:
- brake disk,
- wheel hub nut.
Apply high-strength locking compound to the threads of the bracket mounting bolts.
Install:
- front brake shoe guide assembly with caliper and shoes,
- front brake shoe guide bolts.
Install the wheel speed sensor.
Torque tighten:
- bolts of fastening of a shock-absorber rack to a rotary fist (105 Nm),
- nut or bolt for fastening the ball bearings of the suspension arms (62 Nm),
- nut of fastening of a finger of a ball joint of a tip of steering draft (37 Nm),
- hub nut (280 Nm),
- guide rail mounting bolts (105 Nm).
Install the appropriate front wheel.