Torque | |
Subframe mounting bolts | 110Nm |
Bracket mounting bolts | 44 Nm |
Steering gear mounting bolts | 180 Nm |
Bolts for securing the heat shield to the steering gear | 21 Nm |
Bolt of fastening of the pipeline and low pressure of the hydraulic booster of a steering to a subframe | 21 Nm |
Upper subframe link bolt | 21 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Remove the front wheels.
Secure the cooling system radiator to the upper front cross member with straps.
Remove the front bumper.
Remove:
- fender holders,
- fenders,
- protective screen.
Loosen the nuts (2) stabilizer bar mounts.
Remove:
- top bolts (3) fastening of the connecting rod of the subframe,
- bolts or nuts (4) fastening of the ball bearings of the suspension arms.
Remove the ball joints of the suspension arms.
Remove the bolt (5) securing the power steering low pressure pipe to the subframe.
Turn away bolts (6) fixing the heat shield of the steering mechanism.
Remove:
- steering heat shield,
- bolts securing the steering gear to the subframe.
Tie the steering gear to the body.
Remove:
- bolt (8) fastening jet thrust to the gearbox,
- bolt of fastening of a foot of fastening of jet thrust (9),
- fastening foot.
Turn away bolts (10) mounting brackets for the front suspension subframe.
Disconnect the oxygen sensor harness from the heat shield.
Install (Mot. 1390) under the stretcher
Lower the lift and adjust the outriggers to keep the subframe stable on the tool.
Remove the bolts (11) And (12) attaching the subframe to the body.
Remove brackets.
Fasten the subframe with a strap to the fixture (Mot. 1390).
Raise the lift to separate the subframe from the body.
Remove the parts and assemblies attached to the subframe.
Installation
Parts that must be replaced: subframe mounting bolt.
Degrease the mating surfaces of the subframe and body with a surface cleaner.
Install the parts and assemblies attached to it on the subframe.
Position the subframe under the vehicle using (Mot. 1390).
To guide the subframe during installation, insert M12 threaded rods (13) fixtures (Tav. 1747) into the bolt holes for the front subframe mounting bolts.
Install the brackets.
Install the subframe.
Tighten the subframe mounting bolts in order until they touch.
Torque tighten the subframe mounting bolts in the order shown (110 Nm).
Torque tighten the bracket mounting bolts (44 Nm).
Remove the safety strap (or belts).
Raise the lift.
Install the steering gear to the subframe.
Torque tighten the steering gear mounting bolts (180 Nm).
Install the steering heat shield.
Torque tighten the bolts securing the heat shield to the steering gear (21 Nm).
Attach the oxygen sensor harness to the heat shield.
Install the rear swingarm support.
Install the power steering low pressure pipe to the subframe.
Torque tighten the power steering low pressure pipe bolt to the subframe (21 Nm).
Install:
- ball bearings of the suspension arms on the steering knuckles,
- subframe connecting rods.
Torque tighten the upper subframe link bolt (21 Nm).
Install:
- engine undertray protection,
- side splash guards.
Install the front bumper.
Remove the safety strap (or belts) from the radiator of the engine cooling system.
Install the front wheels.
Connect the battery.