Torque | |
Fittings of fastening of brake pipelines to the hydroblock | 14 Nm |
Fittings of fastening of brake pipelines to the main brake cylinder | 14 Nm |
Removing
Place the car on a two post lift.
Install a pedal hold tool on the brake pedal to reduce the amount of brake fluid escaping.
Remove the engine top cover (if she is).
Remove the soundproofing brackets (if she is).
Loosen the noise absorbing material to the side to gain access to the piping.
Unscrew fittings (2) brake pipelines on the hydraulic unit.
Disconnect from holders brake pipelines.
Unscrew fittings (3) fastening pipelines to the main brake cylinder.
Remove the brake pipelines installed between the hydraulic block and the main brake cylinder.
Installation
Establish brake pipelines between the hydroblock and the main brake cylinder.
Attach the brake lines to the bulkhead.
Wrap:
- unions of brake pipelines from the hydroblock,
- unions of fastening of pipelines to the main brake cylinder.
Torque tighten:
- unions of fastening of brake pipelines to the hydroblock (14 Nm),
- unions of fastening of brake pipelines to the main brake cylinder (14 Nm).
Install:
- noise protection (if she is),
- noise-absorbing material holders,
- engine top cover (if she is).
Remove the retainer to hold the pedal depressed.
Remove air from the brake system.