Contents: Removal 🠛 Installation 🠛
Place the car on a lift.
Attention! Take measures to collect brake fluid to prevent damage to parts and the body in the area of the brake system elements.
Removal
Remove:
- intake noise muffler;
- expansion tank;
- brake fluid level sensor wiring harness;
- reservoir mounting bolt on the master brake cylinder 1.
Remove the brake fluid from the reservoir and remove the reservoir, wrapping it in a rag.
Remove:
- wiring block of the pressure sensor from the main brake cylinder;
- brake lines from the master cylinder, having previously marked them;
- nuts securing the master cylinder to the vacuum booster.
Installation
Note: When removing the brake master cylinder, be sure to replace the O-ring A when installing.
Install the master cylinder onto the brake booster so that the pushrod enters the master cylinder.
Install:
- brake pipes in accordance with the marks made during removal;
- brake fluid reservoir onto the master cylinder. Press it until it clicks into place;
- brake fluid reservoir mounting bolt.
Bleed the brake system (see Air removal operation).