Removal
Remove both rear wheels.
Disconnect the parking brake cables from the rear suspension beam.
Remove:
- pad pressure spring;
- two guide pin plugs;
- two bolts for fastening the guide pins.
Hang the brake caliper from the body and remove the brake pads.
Installation
Move the piston all the way into the cylinder by rotating the piston using the Fre. 1190-01 tool.
Install new brake pads, starting with the inner pad.
Attention! The inner cap is equipped with a pressure spring, which must be inserted into the groove of the wheel cylinder.
Install the bracket onto the guide shoe, starting with the lower guide pin bolt.
Install the guide pins.
Maintain a distance of 20 mm between the elbow of the pipe and the rear brake caliper.
Installing the spring
Insert the spring into the bottom of the bracket.
Using a screwdriver, place the spring onto the top of the caliper.
Connect the parking brake cables. Install the wheels.
Caution! Before driving the vehicle, press the brake pedal several times to set the wheel cylinder pistons to the working position.