Required special tool
- Mot. 1054 TDC lock.
- Mot. 1273 Belt tension gauge.
- Mot. 1289-03 Fork for centering the travel stop of the pendulum suspension.
- Mot. 1355 Mandrel for installing the pump gasket.
- Mot. 1374 Pump gasket remover.
- Mot. 1379 Device for fixing the engine on the subframe.
Tightening torques, Nm
- Crankshaft pulley bolt: 20 + 90°.
- Bolts of fastening to the engine of an arm of a forward right support of a pendulum suspension bracket: 62.
- Bolts of fastening to the body of the bracket of the front right support of the pendulum suspension: 62.
- Nut for fastening the tension roller of the timing belt: 50.
Removing
1. Remove the timing belt (see section «Drive belt gas distribution mechanism»).
2. To remove the crankshaft front oil seal, use tool Mot. 1374. Screw the body of the mandrel into the stuffing box with the nut 1, and then, turning the bolt 2, remove the stuffing box.
Installation
3. Install a new oil seal on the crankshaft shank, being careful not to damage it when passing through the spline for the crankshaft sprocket.
4. Press in the oil seal using tool Mot. 1355.
5. Install a new timing belt (see section «Drive belt gas distribution mechanism»).