Removing
1. Place the vehicle on a two post lift.
2. Disconnect the battery.
3. Remove:
- right front wheel.
- timing belt,
- crankshaft toothed pulley.
4. Press out the front crankshaft oil seal using the tool (Mot. 1577).
Removing elastomer seals
5. Install the puller on the shaft by bending the grips (1) according to the shaft diameter using a knurled disk (2).
6. Screw on the knurled disc (3) before blocking (2), to secure the clamps to the shaft. Screw the extractor into the stuffing box with a hex nut (4).
7. Remove the gland by turning the threaded rod (5).
Installation
1. Clean the bearing surfaces of the oil seal on the crankshaft and on the engine front cover.
2. Press in the front crankshaft oil seal with a mandrel (Mot. 1385).
3. Install:
- crankshaft pulley,
- timing belt,
- right front wheel.
4. Connect the battery.