Removing
1. Place the vehicle on a two post lift.
2. Disconnect the battery.
3. Disconnect:
- gearbox,
- clutch,
- engine flywheel.
Pressing out the stuffing box
4. Press out the crankshaft rear oil seal using the tool (Mot.1579)
5 Install the puller on the shaft by bending the grips (1) according to the shaft diameter using a knurled disk (2).
6. Screw on the knurled disc (3) before blocking (2), to secure the clamps to the shaft.
7. Screw the extractor into the stuffing box with a hexagon nut (4).
8. Remove gland, threaded rod (5).
Installation
1. Clean the bearing surfaces of the oil seal on the crankshaft and on the engine front cover.
Note: It is strictly forbidden to lubricate the outer diameter of the oil seal before installation.
2. Press in the crankshaft rear oil seal with a mandrel.
3. Install:
- engine flywheel.
- clutch,
- gearbox.
4. Connect the battery