1. Remove the wheel from the side of the caliper to be replaced.
2. Loosen the brake hose tip.
Note. Substitute a container to drain the remaining brake fluid from the hose and cylinder.
3. Turn out two bolts of fastening directing blocks to a rotary fist.
4. Remove a support from a rotary fist and disconnect it from a brake hose, having screwed a support from a hose tip.
5. Install the caliper in the reverse order of removal. Tighten the tip of the brake hose completely until the caliper is installed on the steering knuckle. When installing the caliper, make sure that the hose is not twisted. Apply an anaerobic threadlocker to the threads before installing the caliper-to-knuckle bolts. After installation, restore the level of brake fluid in the reservoir of the main brake cylinder and bleed the air from the brake hydraulic drive (see «Bleeding the hydraulic drive of the brake system»).