Parking brake lever travel (according to the manufacturer) should be 5-7 clicks.
The parking brake should hold the car on a slope of 25% when moving the lever in the car interior by 5-7 teeth of the ratchet. If necessary, the parking brake actuator is adjusted from the passenger compartment.
You will need a socket «at 13».
1. Remove the lining of the floor tunnel (see «Removal and installation of floor tunnel lining»).
2. Fold forward the plug installed on the lining of the parking brake drive lever, which closes the parking brake drive adjusting unit.
3. Wrapping or unscrewing an adjusting nut, achieve a course of the lever on 5-7 clicks.
4. Perform several full strokes of the lever and lower the lever until it stops.
5. Jack up the rear of the vehicle and turn the rear wheels by hand. They should rotate evenly, without jerks. Otherwise, repair the parking brake actuator or the rear wheel brakes.
6. Reinstall the adjuster plug and floor tunnel lining.