1. In order to replace the rear wheel brake hose, unscrew the nut that secures the brake pipe to the lower end of the hose...
2.... remove the tip from the bracket on the body and drain the brake fluid from the hose into a container.
Attention! Inspect the hose end retainer.
Replace severely deformed or corroded retainer.
3. Similarly disconnect a brake tube from the top tip of a hose...
4.... and remove the hose.
5. Install the new hose in the reverse order of removal.
Attention! Make sure that the hose is not twisted along the axis during installation.
6. Similarly replace a brake hose of the second back brake mechanism.
7. In order to replace the front wheel brake hose, disconnect the brake pipe from the upper end of the hose, as was done when replacing the rear wheel brake hose (see point 1).
8. Turn out the bottom tip of a hose from the working cylinder of the brake mechanism of a forward wheel and remove a hose.
9. Install the new hose in the reverse order of removal.
Attention! Make sure that the hose is not twisted along the axis during installation.
10. Similarly replace a brake hose of the brake mechanism of the second forward wheel.
11. After replacing the hoses, bleed the air from the brake system (see «Bleeding the hydraulic drive of the brake system»).