Note. The work is shown on the example of a tube connecting the brake hose to the working cylinder of the rear wheel brake mechanism.
You will need a special key «at 11» for brake lines.
1. Remove the tube from the holder on the lever...
2.... and the rear suspension beam.
3. Turn away nuts of fastening of a brake tube to a hose tip...
4.... and to the rear brake slave cylinder, remove the tube.
5. Install the new tube in the reverse order of removal.
6. After replacing the tube, bleed the air from the brake system (see «Bleeding the hydraulic drive of the brake system»).
Note. The brake pipes located on the base of the body are changed in the same way, after removing them from the holders on the base.