1. Disconnect the wire from the negative terminal of the battery.
2. Using a screwdriver, pry off the plug from the rear end of the floor tunnel lining.
3. Remove the screw securing the rear part of the trim to the body base...
4. ...slide the rear part back, disengaging its locks from the front part of the trim...
5. ...and remove the rear part of the floor tunnel trim.
6. Unscrew the nut securing the front part of the trim to the base of the body.
7. Remove the gearshift lever boot (see "Removal, installation and repair of the gearbox control lever linkage").
Source is located on the website www.Renaultbook.ru
8. Remove the ashtray from the trim socket.
9. Remove the two screws securing the front part of the floor tunnel trim, located at the bottom of the cup holders.
10. Lift the front part of the trim, disconnect the wiring harness connector from the cigarette lighter (see "Removing and installing the cigarette lighter socket") and remove the front part.
Note: The car used for the photo shoot has an additional anti-theft alarm system, the indicator lamp of which is mounted on the floor tunnel lining. Before removing the front part of the floor tunnel lining, it is necessary to disconnect the wire from the indicator lamp. This lamp is not included in the standard version of the car.
11. Install the floor tunnel trim and all removed parts in the reverse order of removal.