Note. Replacing the front seat belts is shown using the driver's seat belt as an example. The front passenger seat belt is replaced in the same way.
You will need: TORX T20 and T40 wrenches, «at 16», «at 17».
1. If the seat belts are equipped with pretensioners, disconnect the wire from the terminal «minus» battery.
Attention! After disconnecting the wire from the terminal «minus» battery, you must wait at least 10 minutes, only after that you can proceed to remove the seat belt equipped with a pretensioner. Dismantling of belt tensioners is prohibited. Do not allow the belt reels with pretensioners to fall and get water and oil into them. Do not expose belt pretensioners to temperatures above 95°C.
2. Remove the decorative cap from the lower belt mounting bolt...
3.... and remove the bolt.
Attention! Washers and spacers are installed on the belt mounting bolts, do not lose them.
4. Turn out two screws of the bottom fastening of facing of the central rack of a body.
5. Remove the buckle trim...
6.... and unscrew the bolt of the upper belt mount.
7. Turn out the screw of the top fastening of facing of the central rack of a body.
8. Remove the lining from the rack, overcoming the force of the clamps, pass the bracket for the upper belt mount into its hole...
9.... belt buckle tongue...
10.... an arm of the bottom fastening of a belt also remove facing of a rack.
11. Turn out a bolt of fastening of an inertial coil...
12.... and remove the coil from the body pillar.
13. Loosen the bolt securing the front seat belt buckle to the seat slide...
14.... remove the bolt...
15.... remove the bent mustache of the lock body from the rectangular hole in the slide...
16.... and remove the lock by pulling it out of the slot in the upholstery of the seat cushion.
17. Install the front seat belt in the reverse order of removal.