1. Disconnect the wire from the negative terminal of the battery.
2. Using a screwdriver, pry off the plug from the rear end of the floor tunnel lining.
3. Remove the screw securing the rear part of the trim to the body base...
4. ...slide it back, disengaging the clips from the front part of the trim...
5. ...and remove the rear part of the trim.
6. Unscrew the nut securing the front part of the trim to the base of the body.
7. Remove the gearshift lever boot (see "Removal, installation and repair of the manual transmission control lever linkage").
8. Remove the ashtray from the trim socket.
9. Remove the two screws located at the bottom of the cup holders that secure the front part of the floor tunnel trim.
10. Lift the front part of the trim, disconnect the wiring harness connector from the cigarette lighter (see "Removal and installation the cigarette lighter socket") and remove the front part of the trim.
11. Install the floor tunnel trim and all removed parts in the reverse order of removal.