Share with friends:
Car engine lubrication system Renault Sandero 1
Lubrication system — design features
The engine lubrication system is combined: the most loaded parts are lubricated under pressure, the rest - by splashing. The pressure in the lubrication system is created by a gear oil pump installed in the engine oil...
The engine lubrication system is combined: the most loaded parts are lubricated under pressure, the rest - by splashing. The pressure in the lubrication system is created by a gear oil pump installed in the engine oil...
Changing engine oil and oil filter
According to the manufacturer's recommendation, engine oil should be replaced after 1 year of operation or 15 thousand km of mileage (whichever comes first). Helpful advice: In severe operating conditions in a large...
According to the manufacturer's recommendation, engine oil should be replaced after 1 year of operation or 15 thousand km of mileage (whichever comes first). Helpful advice: In severe operating conditions in a large...
Replacing the chain and gear of the oil pump drive
1. Disconnect the wire from the negative terminal of the battery. 2. Drain the oil from the engine oil pan (see " Changing engine oil and oil filter "). 3. Remove the accessory drive belt (see " Replacement of auxiliary...
1. Disconnect the wire from the negative terminal of the battery. 2. Drain the oil from the engine oil pan (see " Changing engine oil and oil filter "). 3. Remove the accessory drive belt (see " Replacement of auxiliary...
Removal and installation the oil pump
The oil pump is removed for repair when its supply decreases, causing a constant drop in oil pressure in the engine lubrication system. You will need: 10mm and 13mm socket heads. 1. Disconnect the wire from the negative...
The oil pump is removed for repair when its supply decreases, causing a constant drop in oil pressure in the engine lubrication system. You will need: 10mm and 13mm socket heads. 1. Disconnect the wire from the negative...
Oil pump repair
You will need: a TORX TZO key, pliers, a caliper, and a set of flat feeler gauges. 1. Remove the oil pump from the vehicle (see " Removal and installation the oil pump "). 2. Drain the oil from the pump. 3. Remove the...
You will need: a TORX TZO key, pliers, a caliper, and a set of flat feeler gauges. 1. Remove the oil pump from the vehicle (see " Removal and installation the oil pump "). 2. Drain the oil from the pump. 3. Remove the...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Other sections on other Renault models
➽ Power unit: Lubrication system Renault Logan 1 (2004-2012, petrol)
Link to this section in different formats
TEXTHTMLBB Code
- General information
- Structure of car
- User manual
- Troubleshooting
- Maintenance
- Practical advice
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel and exhaust system
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Car body care
- Heater and air conditioner
- Security system
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Ignition system
- Electrical diagrams