Front suspension of car Renault Sandero 1

Front suspension — design features
Front suspension (Fig. 7.1) independent, lever-spring type MacPherson, with telescopic shock absorber struts, coil springs, lower transverse levers. Anti-roll bar is installed on modifications with K4M engine (16-valve,...

Checking the technical condition of the vehicle's front suspension parts
All checks and work should be carried out from underneath the vehicle, installed on a lift or inspection pit (with front wheels up). During each maintenance and repair, it is necessary to check the condition of the...

Removal and installation the shock absorber strut
You will need: keys "13", "17", "18", "21", Allen key "6", key for wheel bolts. 1. Brake the vehicle with the parking brake and install the anti-rollback stops ("shoes") under the rear wheels. 2. Loosen the wheel...

Shock absorber strut repair
You will need: a 6 mm Allen key, a 27 mm key, and a spring compressor. 1. Remove the shock absorber strut (Fig. 7.2) from the vehicle (see " Removal and installation the shock absorber strut "). Fig. 7.2. Shock absorber...

Replacing the front suspension arm
You will need: keys "13", "18", TORXT30. Note. Brake the car with the parking brake and install the anti-rollback stops ("shoes") under the rear wheels. 1. Loosen the wheel mounting bolts, raise the front of the car,...

Replacement of anti-roll bar components
Note: The anti-roll bar is installed on the vehicle modification with the K4M engine (16-valve, 1.6 l). You will need: keys "10", "13", TORX T40, socket head "18". 1. Loosen the nut of the stabilizer bar mounting bolt,...

Removal and installation the steering knuckle
You will need: 18 mm wrenches (two), TORX T30 and T40, 30 mm socket head, ratchet, wheel bolt wrench. 1. Brake the vehicle with the parking brake and install the anti-rollback stops ("shoes") under the rear wheels. 2....

Replacing the front wheel hub bearing
You will need: a bearing puller, a snap ring puller, a punch, a hammer. Helpful advice. To replace the bearing, it is convenient to use a commercially available puller for pressing out and pressing in hub bearings....

Removal and installation the subframe
You will need: keys "10", "13", "16", "18", TORX T30, socket head "18", screwdriver with a flat blade. 1. Remove the mudguards and engine crankcase protection (see " Removal and installation mudguards and engine...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Chassis, running gear: Front suspension Renault Symbol 2 (2008-2013, petrol)
➽ Chassis, running gear: Front suspension Renault Fluence 1 (2009-2020, petrol)
➽ Chassis, running gear: Front suspension Renault Logan 1 (2004-2012, petrol)
➽ Chassis, running gear: Front suspension Renault Espace I and II (1984-1996)

Link to this section in different formats

TEXTHTMLBB Code

Sandero 1 (2007-2012, petrol)