Contents: Removal 🠛 Installation 🠛
Removal
Place the vehicle on a two-post lift.
Release the parking brake.
Remove the rear wheel.
Release the parking brake cable.
Mark the cable route for subsequent installation.
Loosen the guide pin mounting bolts.
Remove the bracket.
Hang the brake caliper to the body.
Remove the brake pads.
Unscrew the two bolts securing the brake shoe guide.
Remove the brake shoe guide.
Check the condition of the brake system components (replace damaged parts).
Clean the shoe guides and brackets.
Installation
Fig. 6.73. Installing the piston inside the cylinder using a special device
Move the piston inside the cylinder using a special tool (Fre. 1190-01) until it stops (Fig. 6.73).
Before installation, apply FRENBLOC to the threads of the brake caliper bracket mounting bolts and guide pins (or its equivalent).
Install the shoe guide.
Install the shoe guide mounting bolts.
Install the parking brake cables.
Fig. 6.74. Installing the parking brake cable stopper
Make sure that the parking brake cable stopper is correctly inserted into the socket (Fig. 6.74).
Pull the parking brake handle several times to operate the parking brake system and the automatic brake pad wear compensation device.
tighten the brake shoe guide mounting bolts to the required torque of 105 Nm.
Install new brake pads, starting with the inner pad.
Install the brake caliper and guide pin mounting bolts.
Check the brake fluid level.
tighten the guide pin mounting bolts to the specified torque of 36 Nm.
Information is located on the website Renaultbook.ru
Install the wheels.
tighten the wheel mounting bolts to the required torque of 105 Nm.
Note: Press the brake pedal several times to set the pistons to the working position.