Note:: replace the part with a new one after each removal.
Saloon version (L52): 1. Tail light. 2. Rear bumper. 3. Rear mudguard. 4. Rear mudguard. 5. ABS sensor cover. 6. Rear bumper support. 7. Rear wheel arch lining. 8. Rear mudguard.
Station wagon version (K52): 1. Trunk lid. 2. Rear bumper. 3. Bumper mount. 4. Rear fender liner. 5. ABS sensor cover. 6. Rear mudguard.
Saloon version (L52): 1. Rear bumper shock absorber. 2. Rear bumper wiring. 3. Parking sensor. 4. Parking sensor support. 5. Rear bumper side bracket. 6. Rear bumper side bracket rivet. 7. Reflector. 8. Rear bumper.
Station wagon version (K52): 1. Reflector. 2. Towing eye socket plug. 3. Rear bumper. 4. Rear bumper wiring. 5. Parking sensor. 6. Rear bumper shock absorber.
Removal and installation the rear bumper, sedan
Removal the rear bumper
1. Place the vehicle on a two-post lift.
2. Remove the clips (1) and remove the rear mudguard.
3. Unscrew the nut (2) and remove the jack (3).
4. Partially remove the rear wheel arch trim.
5. Disconnect the rear bumper wiring from the holder (4).
6. Disconnect the rear bumper wiring connector (5).
7. Remove the rear lights.
8. Remove the license plate light.
9. Unscrew the bolts of the rear wheel arch trim on both sides of the vehicle.
10. Unscrew the lower bolts of the rear bumper.
11. Unscrew the upper bolts of the rear bumper.
12. Remove the rear bumper clips from both sides of the vehicle.
13. Unhook the side sections of the rear bumper first from the front (6) and then from the rear (7).
14. Partially remove the rear bumper (this will require two people).
15. Remove the plug (8).
16. Remove the rear bumper wiring (9) from the body.
17. Remove the rear bumper (this will require two people).
Installing the rear bumper
Installation is carried out in the reverse order of removal.
Removal and installation the rear bumper, station wagon
Removal the rear bumper
1. Place the vehicle on a two-post lift.
2. Remove the jack from the trunk.
3. Unscrew the nuts of the rear wheel arch trim.
4. Partially remove the rear wheel arch trim.
5. Disconnect the wire connector (2) of the rear bumper.
Original publication on the website [Renaultbook.ru]
6. Remove the rear lights.
7. Remove the license plate light
8. Loosen the bolts securing the mudguards to the rear bumper on both sides of the vehicle.
9. Unscrew the lower bolts of the rear bumper.
10. Unscrew the upper bolts of the rear bumper.
11. Remove the rear bumper clips from both sides of the vehicle.
12. Remove the bottom cover clips.
13. Unhook the side sections from the rear bumper first from the front (10) and then from the rear (11).
14. Partially remove the rear bumper (this will require two people).
15. Remove the plug (12).
16. Remove the rear bumper wiring (13) from the body.
17. Remove the rear bumper (this will require two people).
Installing the rear bumper
Installation is carried out in the reverse order of removal.