To ensure the necessary rigidity of the body and the required level of passive safety, the manufacturer recommends adhering to the repair procedures described below.
To ensure an optimal level of safety and quality of the work performed, it is necessary to follow the safety regulations, use the recommended materials and adhere to the described algorithm.
Attention: Be sure to use overalls and protective equipment (gloves, goggles, respirator).
Consideration should be given to the polymerization time of materials when working with them.
All values given correspond to the minimum time during which the vehicle must be stationary at a temperature of 20°C and a relative humidity of 50%.
Do not use these materials at temperatures below 10°C.
It is imperative to observe the minimum time during which the vehicle must stand still in order to ensure maximum safety.
In the process of gluing glass, do not mix different materials with each other.
Only the materials contained in the selected bonding kit can be used.
Mix the primer at least one minute before use.
Do not mix adhesives with solvents, greases, oils, alcohols, primers (before they dry), silicone materials, soap and soapy water.
To remove inclusions (silicone type) Before any operation, clean with distilled water.
Note: In most cases of non-observance of the procedure for gluing glass, the result is a violation of the tightness of the gluing. Apply a bead of glue perpendicular to the surface to be glued.
1. Glass. 2. Cleaning layer.3. Primer on glass. 4. Bead of glue. 5. Primer on the body surface. 6. Residual layer.7. body surface