You will need: T20 TORX wrench, flat blade screwdriver.
1. Disconnect the wire from the terminal «minus» battery.
2. Turn out two bolts connecting the top and bottom parts of a casing of a steering column.
3. Remove the top...
4.... and the bottom of the casing.
5. Remove the transponder ring...
6.... and disconnect the wiring harness block from it.
7. Under the instrument panel is the block of the ignition switch wiring harness. Remove it from the holder by depressing the latch (shown by arrow).
8. Slide the retainer in the direction of the arrow and separate the block.
9. Insert the key into the ignition lock and turn it a quarter of a turn clockwise (label on the ignition switch between positions «A» and «M»).
10. Remove switch harness (castle) ignition from the instrument panel.
11. Turn out a bolt of fastening of the switch (castle) ignition.
12. Press the lock with a screwdriver and remove the switch (lock) ignition from the body.
13. Remove the switch (lock) ignition by pulling its wiring harness out of the housing.
14. Install the parts in the reverse order of removal.