Note. It is necessary to remove the rear suspension beam with assistants who will hold and lower the beam.
You will need: keys «at 18» (two), end heads «at 18», TORX E14, extension.
1. Remove rear wheels.
Attention! Loosen and tighten the wheel bolts only with the vehicle on the ground. Bolt tightening torque 105 Nm (10.5 kgf·m).
2. Remove the brake pipes from the rear suspension beam (see «Replacement of brake pipes»).
3. Disconnect the load rod of the brake force regulator in the rear brake hydraulic drive from the rear suspension beam (see «Replacing the brake force regulator in the hydraulic drive of the rear brakes»).
4. Remove rear suspension springs (see «Replacing the rear suspension spring»).
5. Turn out and take bolts of the bottom fastenings of shock-absorbers.
6. Remove the parking brake cables from the holders on the rear suspension beam (see «Replacing the parking brake cables»).
7. Turn away on both sides on four bolts of fastening of pins, remove them in gathering with brake mechanisms and cables of a parking brake drive, push between a beam of a suspension bracket and the bottom of the car and accurately put on a floor.
8. Turn out on three bolts of fastening of arms of a beam of a back suspension bracket from one and from other party...
9.... and remove the beam assembly with brackets.
10. Turn away nuts of bolts of fastening of a beam to arms, keeping bolts from turning by the second key, and remove arms.
11. Establish a beam of a back suspension bracket in an order, the return to removal. Bolts of fastening of a beam to arms finally tighten on the car standing on the earth.
12. After installing the beam, bleed the brake system (see «Bleeding the hydraulic drive of the brake system») and adjust the parking brake if necessary (see «Parking brake actuator adjustment»).