Tightening torques, Nm
- Nut of fastening of a support of a beam of the back bridge 11.
- Wheel bolt 90.
- Bolt of fastening of the bottom support of the shock-absorber 85.
Removing
1. Place the vehicle on a two post lift.
2. Establish the fixing device on a brake pedal.
3. Remove the nuts securing the lower supports of both shock absorbers.
4. Remove the brake pipes.
5. Remove the brake force regulator.
6. Remove the central heat shield.
7. Remove the brake cables by disconnecting them from the adjuster.
8. Disconnect cables from holders on a fuel tank.
9. Install the rear axle beam on the support and unscrew the nuts 1.
10. Remove the rear axle.
Note: access to the beam support bolts can be obtained after removing the rear seat cushion (depending on vehicle version) and removal of plugs.
Installation
1. Installation is carried out in the reverse order of removal.
2. Remove air from brake contours.
3. Adjust the parking brake.
4. Check and, if necessary, adjust the brake force regulator (see chapter «Maintenance»).