Tightening torques, Nm
- Bolt of fastening of the top support of the shock-absorber 115.
- Bolt of fastening of the bottom support of the shock-absorber 85.
Removing
1. On a car standing on our scaffolding, remove the bolt 1 attached to the lower shock absorber support.
2. Raise the car.
3. Remove the wheel.
4. Remove the upper support bolt 2.
5. Remove shock absorber.
Attention! Shock absorbers are stored in warehouses in a horizontal position. While in this position, the reservoir of the shock absorber, which is designed to operate in a vertical position, may empty. Before installing the shock absorber on the car, squeeze it several times with your hands, holding it vertically.
Installation
1. Install shock absorber.
2. Install the shock absorber upper mount bolt, lubricated with MOLYKOTE BR2 and do not tighten it.
3. Install the wheel.
4. Lower the car.
5. Install the lower shock absorber mounting bolt, pre-lubricated (recommended product MOLYKOTE BR2).
6. Tighten both bolts to the correct torque.