Required special tool
- Sus. 1413 Center stabilizer mount compressing tool.
- Sus. 1414 Stabilizer side support compression tool.
Tightening torques, Nm
- Bolt of fastening of a bracket of a pillow of people of a support of the stabilizer 30.
- Stabilizer side support nut 15.
Removing
1. Place the vehicle on a four post lift.
2. Turn away two bolts of fastening of a flange of a reception pipe to a flange of a rough muffler.
3. Remove the two lift boosters (4 bolts).
4. Turn away two nuts of fastening of lateral support of the stabilizer.
5. Turn away on two bolts of fastening from each bracket of a pillow by the environment of a support of the stabilizer.
6. Check up a condition of support and rubber pillows and if necessary replace them.
Installation
1. Install the stabilizer side mounting nuts using tool Sus. 1414.
2. Install the middle stabilizer mount mount bracket bolts using tool Sus. 1413.
3. Install two subframe reinforcements.
4. Wrap two bolts of fastening of a flange of a reception pipe to a flange of a pipe of the muffler.
5. Finally tighten the bolts and nuts of the stabilizer mounts on an unloaded vehicle.