Removing
Attention! If the boot is damaged, the entire ball joint must be replaced.
1. Place the vehicle on a two post lift.
2. Remove the front wheels.
3. Turn away nuts of fastening of the stabilizer on the bottom levers.
4. Remove the stabilizer down.
5. Remove the nut and pinch bolt from the steering knuckle.
6. Loosen, but do not unscrew the two bolts of fastening 3 levers on the subframe.
7. Remove two ball joint bolts 4.
8. Remove the ball joint.
Installation
Attention! Ensure that the plastic shield A is on the ball joint pin (pic. 6.8).
1. Install the ball joint and tighten the fasteners.
2. Then proceed in the same way as when installing the lower arm.