Tightening torques, Nm
- Wheel bolts 90.
- Nut for fastening the axles of the lower arm to the subframe 90.
- Nut of a coupling bolt of fastening of a finger of a spherical support on a rotary knuckle 55.
- Stabilizer support nut 15.
Removing
1. Place the vehicle on a two post lift.
2. Remove the front wheels.
3. Turn away nuts of fastening of the stabilizer on the bottom levers.
4. Remove the stabilizer down.
5. Remove the nut and pinch bolt from the steering knuckle.
6. Turn away two bolts of fastening of the lever on a stretcher.
7. Remove the lever.
Installation
Attention! Ensure that the plastic shield A is on the ball joint pin (pic. 6.5).
1. Install the lever.
2. Wrap two bolts of fastening, without tightening them.
3. Establish a finger of a spherical torus in a rotary fist.
4. Install the pinch bolt and tighten the nut.
5. Install stabilizer and mounting nuts with tool Sus. 1414. The tool allows you to compress the rubber support pads to screw on the nut.
Attention! Bleed the suspension and tighten the nuts securing the arm axles and stabilizer mounts to the recommended torque (on a car in an unloaded state).