Dimensions H1 and H4 are measured along the wheel axis. Dimension H2 is measured between the bottom surface of the subframe (right under the wheel axle) and earth.
Size H5 is measured along the axis of the silent block.
The position of the control points of the lower part of the body
- 1 - Increased payload.
- 2 - Standard payload.
- 3 - For vehicles equipped with E7J and F8Q engines.
«Minus» in front of the value indicates that the floor is higher than the wheel axle in relation to the ground.
Tolerances:±7.5 mm.
The difference between the right and left side of the same axle of the car must not exceed 5 mm, while the driver's side must always be higher. After carrying out work on changing the position of the control points of the lower part of the body, the brake force limiter and headlights should also be adjusted.
Front suspension
Technical data (standard payload)
Technical data (increased payload)