Note. The work is shown on the example of the left front fender. The right front fender is removed and installed in the same way.
1. Open the hood.
2. Remove the decorative lining of the wing, overcoming the elastic resistance of its caps.
Attention! To avoid breakage of the fastening of the lining, remove it in a certain sequence: first, press the lining towards the center of the car (in this case, one piston will come out of engagement with the body), and then up (the second piston will be disconnected).
3. Remove the front wheel mudguard and front fender liner (see «Removal and installation of wheel mudguards and fender liner»).
4. Remove the side turn signal light (see «Replacement of a lateral lantern of the index of turn»).
5. Remove the front bumper (see «Removal and installation of a forward bumper»).
6. Turn out the bottom bolt of fastening of the block headlight to a forward wing.
7. Turn out bolts of fastening of a wing to a forward rack of a body...
8.... and to the threshold of the body.
9. Turn out a bolt of fastening of a wing to the lower cross-beam of a frame of a radiator.
10. Turn out three bolts of the top fastening of a wing to a framework of a motor compartment and remove a wing.
11. Install the front fender and all removed parts in the reverse order of removal.