Removal and installation the ignition coil of the D4F engine (1.2 l) (Renault Logan 2)

Contents: Removal the ignition coil 🠛 Installing the ignition coil 🠛

Removal the ignition coil

1. Disconnect the negative battery terminal.

2. Remove the air filter unit.

3. Disconnect the high-voltage wires from the spark plugs.

Caution: Do not pull on the wires to disconnect high-voltage wires - pull only on the connectors.

4. Disconnect the ignition coil connector (1).

5. Disconnect the oil vapor recirculation pipe (2).

6. Move the oil vapor recirculation pipe to the side.

7. Loosen the bolts (3) and remove the ignition coil.

Installing the ignition coil

1. Install the ignition coil.

2. Connect the high-voltage wires to the spark plugs.

Note: When installing spark plug wires, apply a bead of FLUORINATED GREASE (PART NO. 82 00 168 855) 2 mm in diameter along the inner edge of the cap.

Note: When installing spark plug wires, apply a bead of FLUORINATED GREASE (PART NO. 82 00 168 855)…

3. Connect the ignition coil connector.

4. Further installation is carried out in the reverse order of removal.

This note was copied from the resource: www.RENAULTBOOK.ru

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Petrovsky Roman

Share with friends:

Logan 2: Engine electrical equipment

Removal and installation the starter, K9K engine (1.5 l diesel)
Removal and installation the starter, K4M engine (1.6 l, 16 valves)
Removal and installation the starter, K7M engine (1.6 l, 8 valves)
Removal and installation the starter engine D4F (1.2 l)
Generator repair

Removal and installation of ignition coil of K7M engine (1.6 l, 8…
Removal and installation of ignition coils of the K4M engine (1.6 l,…
Removal and installation spark plugs, D4F engine (1.2 l)
Removal and installation spark plugs, K7M engine (1.6 l, 8 valves)
Removal and installation spark plugs, K4M engine (1.6 l, 16 valves)