Removal spark plugs
1. Loosen the bolts (1) of the air filter unit cover.
2. Remove the air filter unit cover with the air intake duct.
3. Disconnect the high-voltage wires (5) of the spark plugs.
Caution: To disconnect high-voltage wires, do not pull on the wires - pull only on the connectors.
4. Remove the spark plugs using a 14mm spark plug wrench (Ele. 1382-01).
Installing spark plugs
1. Check and, if necessary, adjust the spark plug electrode gap using a set of flat feeler gauges. Spark plug electrode gap (NGK): 0.65±0.05 mm.
2. Install the spark plugs and tighten them using a torque wrench (Ele. 1933) and a spark plug wrench (Ele. 1933) to 23 Nm.
3. Connect the high-voltage wires to the spark plugs.
Note:
- When installing high-voltage spark plugs, it is necessary to apply a bead of FLUORINATED compound
- GREASE (PART NO. 82 00 168 855) 2 mm in diameter on the pnutron edge of the cap.
4. Install the air filter unit.