Removal and installation the contact disk
Removal the contact disk
1. Set the front wheels of the vehicle to the straight-ahead position.
2. Block the airbag processor.
3. Turn off the ignition.
4. Disconnect the negative battery terminal.
5. Remove the driver's airbag.
6. Remove the steering wheel.
Caution: To avoid damage to the contact disk, do not rotate its moving section.
7. Remove the upper and lower steering column covers.
8. Remove the steering column switches.
Note: When removing, it is necessary to hold the contact disk immobile.
9. Loosen the bolts (1) of the windshield wiper switch and the bolts (2) of the light switch.
Installing the contact disk
Attention:
- To avoid damage to the contact disk, do not rotate its moving section.
- Incorrect installation of the steering wheel may cause damage to the contact disk.
Note:
- During installation, it is necessary to hold the contact disk immobile.
- If the contact disc is replaced with a new one, the contact disc supplied as a spare part is already centered and secured with a sticker that breaks off when the steering wheel is turned for the first time (when installing, the front wheels must be set in the straight-ahead position).
[Material taken from an online portal: www.renaultbook.ru]
Installation is carried out in the reverse order of removal.
After installation, you need to unlock the airbag processor.
Turn on the ignition and check the operation of the contact disk by turning the steering wheel left and right from lock to lock. Return the steering wheel to the center position and make sure that there are no malfunction warning lights on the instrument panel.