Removal and installation of rear side seat belts
Removing the rear side seat belt
1. Remove the back cushion and backrest (whole or separately - 1/3 and 2/3).
2. Remove the lower bolt of the rear side seat belt.
3. Remove the rear shelf (if available) and rear shelf trim.
Sedan
4. Remove the top bolt (2) and remove the rear side seat belt.
Station wagon
5. Remove the top bolt (3) and remove the rear side seat belt.
Installing the rear side seat belt
Installation is made in an order, the return to removal.
Note:
- Coat the threads of the front seat belt buckle bolt with high strength thread locking compound.
- Bolt tightening torque for rear seat belt: 21 Nm.
Check that the seat belt is correctly installed by pulling out approximately 300 mm of the seat belt twice, then releasing and allowing it to retract into the reel.
Test the front seat belt locking function by pulling out about 200mm of the belt webbing and pulling hard to try to pull the belt out further.
Removal and installation of a back central seat belt
Removing the rear center seat belt, sedan
1. Remove the back cushion and backrest (whole or separately - 1/3 and 2/3).
2. Unscrew the lower bolt of the rear side seat belt
3. Remove the trim of the rear shelf
4. Loosen the bolt (1) inertia coil rear center security
5. Remove the rear center seat belt.
Removing the rear center seat belt, sedan
1. Remove the ceiling lining.
2. Loosen the bolt (3) inertia coil of the central seat belt.
3. Remove the rear center seat belt.
Installing the rear center seat belt
Installation is made in an order, the return to removal.
Note:
- Coat the threads of the front seat belt buckle bolt with high strength thread locking compound.
- Bolt tightening torque for rear seat belt: 21 Nm.
Check that the seat belt is correctly installed by pulling out approximately 300 mm of the seat belt twice, then releasing and allowing it to retract into the reel.
Test the front seat belt locking function by pulling out about 200mm of the belt webbing and pulling hard to try to pull the belt out further.
Removal and installation of brackets of rear seat belts
Removing the rear seat belt anchors
1. Remove the back cushion and backrest (whole or separately 1/3 and 2/3)
2. Loosen the screws (1) and remove the rear seat belt buckles.
Installing the rear seat belt anchors
Installation is made in an order, the return to removal.
Note:
- Coat the threads of the front seat belt buckle bolt with high strength thread locking compound.
- The moment of an inhaling of bolts of brackets of back seat belts: 21 Н·м.