Contents: Height adjustment of the shoulder…🠛 Fastening rhenium 🠛 Driver's seat belt warning light 🠛 Unfastening the belt 🠛 Rear seat belts (standard chassis) 🠛
Height adjustment of the shoulder section of the front seat belt
Use button 1 to adjust the position of the shoulder section of the seat belt.
- to lower the belt, press the regulator button 1 from both sides and simultaneously lower the belt;
- to raise the belt, move the adjuster 1 up.
After adjusting the position of the belt, check the reliability of its fixation.
Fastening rhenium
Slowly, without jerking, pull out the belt and insert the tongue into the lock until it clicks (check the reliability of the belt fixation in the 8 lock by pulling the tongue). If the locking mechanism is activated when pulling the belt, loosen the belt tension and then continue pulling it smoothly.
If the belt does not stretch:
- pull the belt slowly but firmly, stretching it out about 3 cm;
- then release the belt so that it automatically retracts into the tensioner;
- pull the belt out again;
- if the belt still does not stretch, contact a Renault service station.
Driver's seat belt warning light
The lamp lights up and burns continuously. And when the speed reaches approximately 10 km/h, it flashes for 90 seconds. At the same time, a signal sounds, after which the lamp burns continuously again.
Unfastening the belt
Press the lock button The belt is automatically retracted into the tensioner
To make this operation easier, hold the tongue with your hand.
Rear seat belts (standard chassis)
Rear outboard seat belts
Slowly pull belt 1 out of the slot.
Be sure to pass it through the guide.
Snap tongue 2 into black lock 3.
View the original on the specified resource: www.renaultbook.ru
Insert the last sliding tongue 4 into the red lock 5.
Rear middle seat belt
Slowly pull belt 6 out of the socket.
Snap the tongue 7 into the black lock.
Insert the last sliding tongue 8 into the red lock 9.