Contents: Manually adjustable front seats 🠛 Headrests 🠛 Electrically adjustable front seats 🠛 Removal and installation the…🠛
 |
 |
Manually adjustable front seats
Correct installation of seats is necessary to ensure:
- access to controls
- comfort of travel
- maximum efficiency
operation of seat belts and airbags.
No objects should be placed on the floor in front of the driver's seat, as in the event of emergency braking or even a minor impact, they may end up under the pedals and make it difficult to control the car.
Longitudinal adjustment
Lift the wide handle located under the seat cushion and move the seat forward or backward. Then release the handle and move the seat a little further until the lock engages. The position of the seat relative to the longitudinal plane must be adjusted so that the pedals can be fully pressed with slightly bent knees.
(You can find the original at this link: Renaultbook.ru)
Adjusting the height of the driver's seat cushion
Lift yourself off the seat cushion and move the handle located on the outside of the seat cushion:
- up to raise the seat cushion;
- down to lower the seat cushion.
Adjusting the angle of the seat backrest
The seat back must not be tilted too far back while driving, as this significantly reduces the effectiveness of the seat belts. Move the handle located on the outer lower side of the seat back to set the desired angle of the back. If you need to tilt the back forward, first lean away from the back. The position of the seat back must be adjusted so that the back is completely against your back, and the top of the steering wheel can be reached with slightly bent elbows.
Adjustment of support and lumbar region
Turn the knob located on the inside of the seat back to adjust the lumbar support.
Headrests
The removable headrests can be adjusted in height and angle.
To adjust the position of the headrest, grasp it with both hands at the sides and slide it up or down.
To adjust the angle, tilt the top of the headrest forward
Removal and installation
Pull the headrest up as far as it will go.
Press the tab and pull the headrest up.
Insert the headrest into the guide slots and lower it to the desired position.
Note: Head restraints are an essential safety feature of a vehicle. To be effective, the head restraint should be positioned as close to the top of the head as possible.
Electrically adjustable front seats
The position of the seats is adjusted using switches.
Memorizing the seat position
This system allows you to store the position of the front seat in memory, which can be restored after the adjustment has been disturbed. Memorizing the position of the seat is carried out as follows:
- turn on the ignition;
- adjust the position of the front seat;
- press the "Memoire" button and wait for the beep.
To recall a memorized position, briefly press the "Memoire" button.
Removal and installation the backrest of the rear bench seat
To remove the backrest, fold down the rear seat cushion. Remove rear seat cushion 1.
Recline the seat backs, folding in 1/3 and 2/3 ratios.
Remove the luggage compartment mat.
Remove screws 2.
Fold down the 2/3 split rear seatback.
Remove the bolts securing the 1/3 split rear seat backrest and remove the rear seat backrest.
The 1/3 split fold front seat back is installed before the 2/3 split fold rear seat back is installed.
Install the rear seat backrests. Folding in a ratio of 1/3 and 2/3.
Tighten the rear seatback mounting bolts. Folding in a ratio of 1/3 and 2/3.
Install the rear seat cushion.