Hatchback models
1. Remove the luggage compartment shelf.
2a. Fold down back seats and disconnect electroconducting from the back loudspeaker from a side subject to removal of a belt. Turn out screws of fastening of a corresponding arm of a back shelf.
2b. Remove bracket (refer to illustrations).
3a. Release the rear door opening sealing strip from the rear seat locking side trim panel. Turn out a lock finger of a back of a back seat.
3b. Remove trim panel (refer to illustrations).
4. Remove the lower seat belt anchor bolt (refer to accompanying illustration).
5a. Release the latches and remove the upper rear shelf trim panel by passing the seat belt webbing through it.
5b. When removing the panel from the left pillar, you will also have to disconnect the wiring from the luggage compartment light (refer to illustrations).
6. Turn out a bolt of fastening of an inertial drum of the returnable device and remove a back seat belt (refer to accompanying illustration).
Coupe models
1. Remove the rear seat cushion (see Section Removal and installation of seats) and fold forward its back.
2. Turn out the bottom anchor bolt and release a tape of a belt from the panel of a lateral furnish of salon.
3. Remove the A-pillar top trim panel (see paragraphs above), Peel off the doorway sealing strip from the edge of the panel.
4. Carefully release from the C-pillar trim panel and disconnect the heated rear window wiring connector (refer to accompanying illustration).
Attention! To avoid breakage of the current-carrying core, try not to bend the wire excessively!
5a. Remove the fixing screw, then release the clips and the C-pillar trim panels (refer to illustrations).
5b. Remove the panel by threading the belt through it.
6. Turn out a bolt of fastening of an inertial drum of the returnable device and remove a seat belt from the car.
Sedan models
1. Remove the top level spotlight (see chapter Onboard electrical equipment). On models equipped with rear speakers, remove the speaker grilles from the rear shelf.
2. Release the latches and remove the rear seat cushions, then (of necessity) Remove the lower seat belt anchor bolt.
3. Release the decorative cover of the corresponding seat belt from the trim panel of the rear shelf (refer to accompanying illustration).
4a. Fold forward the rear seatbacks, then carefully remove the clips securing the front edge of the rear shelf trim panel.
4b. Gently pull forward to separate the panel from the shelf (refer to illustrations).
5. Give a bolt of fastening of an inertial drum of the returnable device and remove a seat belt from the car, passing its tape through a groove in the panel of finishing of a back shelf.
Installation
1. Installation is carried out in the reverse order. Follow the correct fastening of the assemblies of the inertial drums of the return devices on the body panels of the car, as well as the reliability of tightening the fasteners. Evaluate the reliability of fastening with your screws and retainers for trim panels and covers.