Attention: Vehicles supplied to the market in some countries may be equipped with mechanical front seat belt tensioners. In such vehicles, it is forbidden to try to remove the belts yourself; in case of need address on HUNDRED Renault.
Attention: Before removing the seat belts, remember the location of the washers, spacers and spacers at the points of fastening of the belts and install these parts strictly in their places when assembling.
Front seat belts
Removing
1. Remove the cap, and then unscrew the lower bolt of the belt on the body (see illustration).
20.1 Lower belt mounting bolt
2. Loosen the bolt at the top where the belt exits the rack and remove the cap to access the internal fastening buttons.
3. Remove the cap of the upper belt mounting bolt on the body (see illustration).
20.3 Upper belt bolt
4. Turn away the top bolt of fastening and remove a plate of a belt.
5. Turn away a bolt of fastening of an inertial coil, then remove a seat belt (see illustration).
20.5 Inertial coil fixing bolt
Installation
6. Installation is carried out in the reverse order. Make sure all gaskets, washers and spacers are in place. Tighten all screw connections to the specified torque.
Front seat belt brackets
Removing
7. Each of the brackets is fixed either on the seat or on the cabin floor.
8. Remove the cap from the bracket mounting bolt (if the bracket is attached to the floor of the passenger compartment), unscrew the bolt and remove the bracket. If the bracket is installed on the seat, remove the bolt that secures it to the seat.
Installation
9. Installation is carried out in the reverse order. Tighten the bracket bolt to the correct torque.
Rear seat belts
Removing
10. Remove the inner lining from the wheel arches by unfastening the fastening buttons and unscrewing the bolt.
11. Remove the decorative cap from the upper bolt of the seat belt on the body, unscrew the bolt and remove the bracket (see illustration).
20.11 Seat belt bolts 1. Bracket mounting bolts; 2. Bolts for fastening inertial coils
12. Turn away a bolt of fastening of an inertial coil.
Installation
13. Installation is carried out in the reverse order.
Rear seat belt brackets
Removing
14. Remove the decorative cap from the bracket mounting bolt.
15. Turn away a bolt and remove an arm.
Installation
16. Installation is carried out in the reverse order. Tighten the bracket bolt to the correct torque.