Side doors — removal and installation Removing Front doors 1. Remove an internal covering of a door. 2. Disconnect the door wiring, then coil the wire so that it protrudes from the other side. 3. Using pliers, remove the cotter pin securing the door...
Rear door — removal and installation Removing 1. Disconnect the wire «masses» from the battery. 2. Remove an internal covering of a door. 3. Ask an assistant to support the door, disconnect the gas springs by removing their fastening clips and...
Front door trim — removal and installation Removing Cars of the 1st and 2nd stages of production 1. Disconnect the wire «masses» from the battery. 2. Disconnect the triangular mounting of the rear-view mirror. 3. Carefully remove the glass sealing brush from the...
Sheathing of the rear side doors — removal and installation Almost all operations for removing and installing the inner trim of the rear side doors are identical to the operations for removing and installing the trim of the front doors ( see previous chapter ). On vehicles...
Rear trim (fifth) doors — removal and installation Removing 1. Open the rear door, remove the protective plastic caps and unscrew the screws securing the inner handle (see illustration). 9.1 Loosening the rear door handle screw 2. Remove the fastening button and the...
Front door glass — removal and installation Removing 1. Remove the inner door trim ( see chapter 7 ). 2. Remove the sealing brushes at the top of the door frame. 3. Install the glass in a position where the lower glass mounting bolts in its holder will be...
Rear door glass — removal and installation Removing Cars of the 1st and 2nd stages of production 1. Remove the door trim ( see chapter 9 ). 2. Raise the glass, and then unscrew the screw under the door latch and the glass holder bolt. Pull out the door guide...
Front door windows — removal and installation Removing 1. Disconnect the wire «masses» from the battery. 2. Do the operations pp. 1-3 Chapters 11 , but do not remove the glass completely. Secure the glass in the fully raised position with adhesive tape or wedges....
Rear door power windows — removing and stopping Removing Cars of the 1st and 2nd stages of production Worm-type window regulators 1. Remove the door trim ( see chapter 8 ). 2. Fix the glass in its highest position with adhesive tape or wedges. 3. Turn away two bolts...
Rear door elements — removal and installation Removing 1. Remove the tailgate trim ( see chapter 9 ). 2. Disconnect the wire «masses» from the battery. Latches 3. To remove both latches, disconnect the blocking rods - rovki their levers; to do this, either unfasten...