Car rear suspension Renault Espace 3

Rear suspension — general information
The rear suspension has a rigid rear beam with two longitudinal levers and a Panhard transverse beam. The coil springs and shock absorbers that form the suspension elements are located separately. Vehicles can be...

Rear suspension — technical data
Fig. 11.1. Rear suspension elements: 1 - upper shock absorber mount; 2 - lower shock absorber mount; 3 - cylindrical spring; 4 - attachment of the longitudinal arm to the body Fig. 11.2. Rear suspension: A - mechanical...

Rear suspension spring
Removal Place the vehicle on a 4-post lift. Place a jack under the rear beam and lower the lift so that the beam rests on the jack and the suspension spring is partially compressed. Remove the bolts securing the lower...

Rear wheel hub and bearing
The cars are equipped with rear wheel hubs with integrated bearings. The bearing and hub form a non-separable unit. Damage to one of the components requires replacement of the entire unit. Removal Using tools Rou. 943...

Hub stub with rear drum brakes
Removal Remove the hub - brake drum assembly. Disconnect the line from the wheel cylinder. Remove the brake shoe backplate mounting stud retaining nut, marking it to return it to its original position. Remove the six...

Hub stub with rear disc brakes
Removal Remove the brake mechanism assembly. Remove the brake disc and hub. Remove the six trunnion mounting bolts. Remove the ABS sensor mounting bolt. Installation Installation is carried out in the reverse order of...

Electronically controlled height control system — general information
The electronically controlled body height control system is a system for maintaining a constant body height regardless of the load installed on vehicles with rear suspension with air springs. The pneumatic part of the...

Rear suspension beam with body height maintenance system
Removal Removal of the rear suspension beam with the body height maintenance system is carried out in the same way as the rear suspension beams without the body height maintenance system, taking into account the...

Air springs
Attention If it is necessary to replace one air spring, the second spring must also be replaced. Any intervention in the pneumatic system requires replacement of the pipeline seals. Before carrying out repairs on the...

Panhard tie rod
Fig. 11.12. Removing the Panhard transverse rod: 1 - Panhard transverse tie rod mounting bolt to rear beam; 2 - bolt for fastening the Panhard transverse rod to the car body; 3 - Panhard transverse rod; 4 - rear bank...

Rear suspension arm silent blocks
The silent blocks are replaced using a press on the removed rear suspension beam. When pressing in, position the silent block as shown in Figure 11.13. The axis of the hole in the silent block for the suspension arm...

Compressor unit
Removal Disconnect the cable from the negative battery terminal. Through the valve on the tee ( fig. 11.8 ) release compressed air from the system. Disconnect the pipe from the tee. Disconnect the electrical wiring...

Level sensor
Removal Disconnect the cable from the negative battery terminal. Remove the bolt securing the sensor traction arm to the rear axle. Remove the 2 bolts securing the sensor to the body. Release the wire retainer and...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Chassis, running gear: Rear suspension Renault Symbol 2 (2008-2013, petrol)
➽ Chassis, running gear: Rear suspension Renault Fluence 1 (2009-2020, petrol)
➽ Chassis, running gear: Rear suspension Renault Sandero 1 (2007-2012, petrol)
➽ Chassis, running gear: Rear suspension Renault Logan 1 (2004-2012, petrol)

Link to this section in different formats

TEXTHTMLBB Code